Drill Package EVH 2100R Drill Rig, Service Vehicle, Compressor, Trailer, Tanks, rods and more

EVH 2100R Drill Rig mounted on 1998 John Deere Tractor 40 hp.  
• (Serial Number: 2100R/0407/77)
• Rig and John Deere just serviced.
• Rig  Hours- 1378 Hours. Old 848 hours new
• Drill Head Rebuilt 2018
• Main + 2 X AUX hydraulic pumps replaced
• New Hydraulic step up box installed
• New Tiban Mud Pump 3 x2” Installed driven by 35hp B&S twin cylinder.
• Bean Pump on rig ( fairly new).
• New slips and head bushes renewed 3 weeks ago

Elgi 200/650 Compressor 2012 (serial Number: OLLD200008).   Service just completed
• Current Hours- 932 Hours 
• Runs off truck diesel tanks.
• Additional 1,000 ltr tank & pump.
• Numerous filters and separators 

Mitsubishi FS428 1994 (9EI846)
• Just had full service.
• Current Mileage- 77820 Km
• Injector pump overhauled - new lift pump and injectors.
• truck stripped, sand blasted, and 2 pack repaint
• Motor Rebuilt at 770 000 Km - new sleeves & pistons and crank bearing.
• New power steering & water pump
• New jack shaft
• Tray reconditioned with 5mm checker plate floor
• Front and back diffs fully rebuilt - diff locks
• Centres bearings, Uni Joints replaced on Drive line
• New Fuels lines installed
• Clutch replaced
• Tray re-wired
• All airlines re-placed
• All Air control valves replaced
• Tyres 90%.
• New Bosch batteries

Polmac trailer
• 7m 2 axle TARE 1.86. GVM. 6000 - air brakes
• New bearings and brakes 30 km ago.

Rods & bits
• 2 x 3” Hammers
• 2 x 4” Hammers
• 1 x 6” Hammer with 7 1/4” bit medium/hard - unused.
• 1 x 5” 1.8 mtr Starter Bar 300kg
• 1 x 5” 1.5 mtr Starter Bar 300kg
• 55 x 3” 1.8 mtr Drill Pipe 3” remet Thread Pin-Box
• 15 x 6” Hollow flight Auger 1.5 mtr
• 14 x 4” Hollow flight Auger 1.5 mtr
• 17 x 6” Solid Flight Auger 1.5 mtr

Assorted bits and subs to suit

500 metres of 19mm copper earth rods including joiners with calibrated ohms meter

3 x Aluminum Mud Tanks and hoses
• Tanks 1000 ltr each
• Bentonite mixer
• 4” foot valve into tank

Ramps
• Set of Aluminium ramps 3.5 metre rated 6 tonne
The rig package is complete ready to go drilling. Air, hammer, auger, mud, transformer earthing work.